12
Step 4 – Configuring locks and communication hubs Wizard
This procedure describes a configuration example of locks and communication hubs using: Override
credential card, secure communication and DIP Switch addressing mode.
For other settings and addressing modes, refer to Aperio Online Programming Application manual,
ref [1].
∙ Before configuration, check that Update device time during door configuration is activated. Enter
the Settings - Installation Settings window.
Follow the steps below to perform a default configuration of locks/sensors and communication hubs:
The changes you make during the update of the door configuration are not carried out until
you perform the device update on the last page in the wizard.
1) Select a lock in the scan result table, right click and select Lock - Configure (or Lock/sensor - Configure if several
locks are paired).
To Next Page
Loading...
