39
ENEN
Notes
Intended use
Electrical locking devices of doors along escape routes are intended for use in
commercial applications.
The product has been designed for the safeguarding of escape routes and has
been tested according to the requirements of EltVTR.
Deviating uses or device combinations not described in the approval are not
permitted.
The product is only suitable for surface-mounted wall mounting.
The mounting, installation and commissioning of the product must be carried out
by an electrician, with expertise in escape-door control systems, certified by ASSA
ABLOY in accordance with the building authority requirements for electrome-
chanical locking on doors in escape routes. The electrician is obligated to apply
the recognised rules of technology and test regulationsof the federal states and to
keep this state of knowledge up to date.
It must be possible to disconnect the device from the power supply circuit at any
time using an easily accessible energy-isolation device.
ASSA ABLOY Sicherheitstechnik GmbH can provide the necessary planning informa-
tion for approved solutions and the device combinations required for your
application. The usage must be coordinated with the requirements of the
inspection authorities. Contact the responsible inspection authority for this
purpose.
Compliance with all relevant inspection authority requirements is mandatory for
use, particularly with respect to the
· coordination of the safety concept with the responsible inspection authority
and
· modifications of door elements.
The device is suitable for mounting, installation, configuration and use as per
these instructions. Any use beyond this is deemed as non-intended use; devices
combinations which are not described are not permitted.
To Next Page
Loading...
