Assa Abloy Norton 7200 Series - Smoke Detector Electrical Connections; Surface Mount Power Input; 120 V AC Input Wiring; 24 V AC;DC Input Wiring

Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
ASSA ABLOY
80-9372-0100-020 (02-14)
13
• Power input to unit must be of the same voltage as that listed on the label.
• All wiring connections use standard wiring practice conforming to local wiring codes.
• Maximum wire size is 18AWG.
• Make input power connections to the terminal block or power supply using illustrations below.
SMOKE DETECTOR
ELECTRICAL CONNECTIONS
120V AC INPUT
Surface mount power input:
Remove appropriate
shaded area from
cover for surface
wired installations
only. Repaint cut
edges as necessary
to prevent corrosion.
7/8"
7/8"
2-5/8"
Clearance
For Strain Relief
Cover surface
facing ceiling.
24V AC/DC INPUT
!
Caution:
Determine proper
input power; 24V or 120V.
Make power connections as shown below.
Make power connections as shown below.
Stand-Alone wiring instructions below. (To incorporate other devices, see
included wiring instruction manual: 80-9342-0904-000)
24VDC Input
Power Only
Terminal Block
Make Connections
Here
24V(+)
24V(-)
Test/Reset
Switch
Terminal Block
Make Connections
Here
On/Off
Switch
Live
Neutral
Ground
Power Supply