Copyright © 2016, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
07/31/16
IN100 Cylindrical Lock
10
Outside Reader Installation
1. Orient the reader so the LED lens is at the top (Fig. 10A).
2. Feed the cable/connector through the door (from outside to inside).
3. Install the reader to the outside of door by aligning the mounting posts with the door
preparation holes. Hold the reader flush against door while ensuring proper alignment.
Fig.
10A
Outside of Door
LED
Reader Assembly
with Harness
NOTE: Cable lengths exaggerated for illustrative purposes.
To Next Page
Loading...
