Associated Research OMNIA II 8206 - Bus Remote Interface USB; GPIB; RS-232; USB;RS-232 Interface

104
This message appears on the display if the DUT input voltage drops below the Volt-
LO Trip setting.
Amp-HI
This message appears on the display if the current exceeds the Amp-HI Trip setting.
Amp-LO
This message appears on the display if the current drops below the Amp-LO Trip
setting.
Line-OC
This message appears on the display if the 20 Amp < 1 s, short circuit protection is
tripped.
Watt-HI
This message appears on the display if the DUT input wattage exceeds the Watt-HI
Trip setting.
Watt-LO
This message appears on the display if the DUT input wattage drops below the Watt-
LO Trip setting.
PF-HI
This message appears on the display if the Power Factor exceeds the PF-HI Trip
setting.
PF-LO
This message appears on the display if the Power Factor drops below the PF-LO Trip
setting.
Leak-HI
This message appears on the display if the enclosure to neutral leakage current
exceeds the Leak-HI Trip setting.
Leak-LO
This message appears on the display if the enclosure to neutral leakage current drops
below the Leak-LO Trip setting.
Neutral-V
This message appears on the display if there is voltage present on the Neutral of the
DUT input receptacle.
OCP
This message appears on the display if the maximum current draw exceeds the
capability of the internal power source (>4.2A).
A-SHDN