57
Save
To save a file with its current name press the “Save” soft key from the File Setup
screen.
Save As
To save an edited file without overwriting the original or to give a file a new name,
press the “Save As” soft key from the File Setup screen. The Create File screen will
now be displayed. For a detailed description of creating a new file, refer to the section
4.5. Setting Up a Test.
Delete
To delete a file, use the up and down arrow keys and scroll the highlighted area to the
file you wish to delete and press the “Delete” soft key. A warning will appear on the
screen asking if you want to delete the file. Press the ENTER key to complete the
deletion or press the EXIT key to escape.
Load
To load a test file, use the up and down arrow keys and scroll the highlighted area to
the file you wish to load and press the “Load” soft key.
4.3.6. Fail Stop
Fail Stop is a function that will stop a sequence of tests if a failure occurs. If this
function is turned OFF the sequence of tests will continue to the end of the sequence
regardless of whether or not a failure has occurred. If the Fail Stop is OFF and a
failure occurs during the test sequence, the RESET button will light and a short alarm
will sound but the sequence will continue. At the end of the test sequence, the
RESET button will light and alarm will sound indicating failure during the sequence.
Pressing the RESET button will silence the alarm and reset the instrument.
To Next Page
Loading...
Need help?
General
