EasyManuals Logo

Associated Research OMNIA II 8206 User Manual

Default Icon
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
114
perform an actual test and all safety precautions should be observed when using this
command.
SACG
Set the Charge-LO parameter for the DCW or IR test. The cables and any test fixture
should be connected before executing the command. The test parameters that are
set for the step will be used when performing the auto setting. This command will
perform an actual test and all safety precautions should be observed when using this
command.
7.4.3. File Editing Commands
The following commands are used to create or modify Test Setup Files.
COMMAND
DESCRIPTION
VALUE
FL nn
File Load nn
nn = 01-9999
FD
File Delete
Active selected File
FD nn
File Delete by
Number
nn = 01-9999
FS
File Save
Active selected File
FSA nn,xxxx
File Save-as
nn = 01-9999, xxx =
name
FN nn,xxxx
File New
nn = 01-9999, xxxx =
name
SS nn
Step Select
nn = 01-9999
ADD <test,p1,p2,p3…>
Adds all
parameters
ADD2<test,p1,p2,p3…>
Adds all
parameters
SAA
Step Add ACW test
SAD
Step Add DCW test
SAI
Step Add IR test
SAG
Step Add GND test
SAC
Step Add CONT
test
SAGA
Step Add GND,
ACW tests
SAGD
Step Add GND,
DCW tests
SAR
Step Add RUN test
SAL
Step Add LCT test
SD
Step Delete
Active selected Step
SD nn
Step Delete by
Number
nn = 01-9999

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Associated Research OMNIA II 8206 and is the answer not in the manual?

Associated Research OMNIA II 8206 Specifications

General IconGeneral
BrandAssociated Research
ModelOMNIA II 8206
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals