Note: S1~S4, HDI are the upper terminals on
the control board and P05.12 can be used to
set the function of S5~S8
0: No function
1: Forward rotation operation
2: Reverse rotation operation
3: 3-wire control operation
4: Forward jogging
5: Reverse jogging
6: Coast to stop
7: Fault reset
8: Operation pause
9: External fault input
10:Increasing frequency setting(UP)
11:Decreasing frequency setting(DOWN)
12:Cancel the frequency change setting
13:Shift between A setting and B setting
14:Shift between combination setting and A
setting
15:Shift between combination setting and B
setting
16:Multi-step speed terminal 1
17:Multi-step speed terminal 2
18:Multi-step speed terminal 3
19:Multi- stage speed terminal 4
20:Multi- stage speed pause
21:ACC/DEC time 1
22:ACC/DEC time 2
23:Simple PLC stop reset
24:Simple PLC pause
25:PID control pause
26:Traverse Pause(stop at the current
frequency)
27:Traverse reset(return to the center
frequency)
28:Counter reset
29:Torque control prohibition
30:ACC/DEC prohibition
31:Counter trigger
32:Reserve
33:Cancel the frequency change setting
temporarily
34:DC brake
35: Reserve
36:Shift the command to the keypad
37:Shift the command to the terminals
38:Shift the command to the communication
To Next Page
Loading...