EasyManua.ls Logo

Astralpool Viron EQ18 - Page 27

Astralpool Viron EQ18
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Viron eQ Salt Chlorinator With Bluetooth | Installation and Operation Manual
Page 27
Fault Indication Possible Cause Solution
pH too high • Probe/sensor malfunction • Clean and calibrate probe/sensor
Chlorine too high • ORP level is set too high
• Total Alkalinity too low
• ORP sensor is not immersed in pool
water
• Cyanuric Acid (Chlorine Stabiliser) is
present in pool
• Reduce to between 600 and 650 mV ORP
• Test TA and adjust to 80 to 120 ppm
• Install sensor chamber so that it is always in pool
water
• Lower ORP set point
Clock loses time when
main power is removed
• Clock power backup failed • Call a technician
Table 6. Troubleshooting