Astralpool Viron EQ18 - Fault X Error Codes; System Default Settings

Viron eQ Salt Chlorinator With Bluetooth | Installation and Operation Manual
Page 29
14.2 Fault X Error Codes
PH FAULT X
RETRYING
SET LIGHT MAINT
1 No comms, Not connected
3 Can’t read comms
17 Too much variation in the PH/ORP measurements
18 PH/ORP Measurement is too high
19 PH/ORP Measurement is too low
14.3 System Default Settings
Pump Timer
1 - 4
ENABLED: True
START HR: 8/16/10/10
START MN: 0
HRS ON: 4/4/2/2
MINS ON: 0
SPEED: High
ZONES ENABLED: 1
Light Timer
1 - 2
ENABLED: True
START HR: 18/20
START MN: 0
HRS ON: 2
MINS ON: 0
PARAMETERS: 0
ZONES ENABLED: None
Lighting
Setup
Zone 1 - 2
MODE: Manual
STATE: Off
COLOUR: Blue
NAME: Pool/Spa
Lighting
Initial
Settings
INSTALLED: False
TYPE: SLX
ZONES: One
Manual on Pump Speed
HIGH
Chlorinator Mode
OFF
Pool/Spa Selection
POOL
Set PH
HIGH
Timer Model
TRUE
Pool Volume
60,000
Spa Volume
Water Measurement Type
3,000
LITRES
G4 System
FALSE
Reversal
Parameters
POLARITY TIME HRS: 0
PERIOD: 4
POLARITY: Forward
Rince Acid Enable
TRUE
Pump Protect
Fast Comms
TRUE
TRUE
Pool/Spa Control Enabled
FALSE
Chlorine Probe Fitted
FALSE
Eco Mode
Water Volume Times
FALSE
1.5
Filter Pump Size
1HP
Manual Pool Chlorine Level
4
Set ORP
600
Probe
Status
PH DETECTED: True
ORP DETECTED: True
PH DISABLED: False
ORP DISABLED: False
Three Speed Pump
FALSE
NOTE: These setting can be reset through the Install Menu.