To Next Page

To Previous Page

7 MAINTENANCE

7.19 Chassis/Engine Cleaning

Periodic cleaning of the chassis area beneath the cab and engine compartment is

also necessary to maintain safe operation. Clean as necessary. (fig. 7.19-1)

To clean the chassis/engine:

1. Shut the machine down as described in section 5.12, allow the machine to

cool thoroughly, then lower the access panels on the underside of the

machine.

2. Open the hood open at the rear of the machine.

3. Pressure wash any debris from the engine compartment out through the

lower openings.

4. Pressure wash any debris from the chassis area out through the lower

openings.

5. Re-secure the acess panels, then close and secure the hood to complete

the cleaning procedure.

Coolant and machine components can be HOT! Allow the machine to

cool thoroughly prior to performing maintenance or service to avoid the

possibility of burns.

If any safety signs are found to be damaged or missing after cleaning,

contact your dealer for a replacement immediately. They can be reap-

plied according to the location illustration in section 2.3 of this manual.

RT-40 US O&M

0404-766 2019-05

7.19-1

7.18-1

If your machine is equipped with air conditioning, there is an accessory belt

driving that system located beneath the seat. Keep the chassis area around the

pulleys clean and clear of debris to ensure proper function.

NOTICE

Questions and Answers:

Need help?

Do you have a question about the ASV RT-40 and is the answer not in the manual?

ASV RT-40 Specifications

General