AT&T 1070 - Make an Intercom Call with the Speakerphone or Headset

27
Intercom operation
Intercom
Make an intercom call with the speakerphone
or headset
With the handset in the telephone base:
1. If One-touch preference is set to INTERCOM, skip
to step 2.
-OR-
If One-touch preference is set to TELEPHONE,
press [INTERCOM]. The phone will
automatically activate the intercom call in
the mode (headset or speakerphone) you
programmed (see AUTOMATIC MODE on page
39 of the installation guide.).
2. Press the one-touch button. The screen will
display INTERCOM TO XX, with XX being the
destination extension you are calling.
If the destination extension is idle or set to Do
Not Disturb, you will hear long beeps. If the other
extension is busy, you will hear a busy signal.
NOTE: The intercom call is automatically can-
celed if you do not press a one-touch button with-
in 10 seconds.
10:01AM 11/23
EXT 11
INTERCOM TO
PAGE
10:01AM 11/23
EXT 11
INTERCOM TO 12