AT&T 1070 User Manual

38
One-touch setup and operation
To dial a one-touch number
This phone comes with one-touch preference
preset to INTERCOM.
NOTE: To change the one-touch preference, see
PREFERENCE on page 35 of this manual.
If one-touch preference is set to INTERCOM:
1. Lift the handset.
-OR-
Press [ SPEAKER].
-OR-
Press [HEADSET] and listen for the dial tone.
2. Press the one-touch button.
-OR-
Press [LOWER], then press the one-touch
button for the destination number you want
to call. The screen displays the number as it is
dialed.
If one-touch preference is set to TELEPHONE:
You do not need to go off hook and listen for a
dial tone before dialing a one-touch number. You
can simply:
Press the one-touch button.
-OR-
Press [LOWER], then press the one-touch button
for the desired number to call.
The screen displays the number as it is
dialed using the speakerphone or headset
as programmed for automatic mode. (See
AUTOMATIC MODE on page 39 of the installation
guide.)
7

AT&T 1070 Specifications

General

Lines Supported	1
Speakerphone	Yes
Caller ID	Yes
Display	LCD
Intercom	Yes
Handset Locator	No
Call Waiting	Yes
Volume Control	Yes
Redial	Yes
Power Source	AC Adapter
Type	Corded