AT&T 1070 - Page 43

37
One-touch setup and operation
One-touch storage
continued from previous page
6. Press the desired one-touch key to store the
telephone number in the normal location.
-OR-
Press [LOWER], then the desired one-touch
key to store the telephone number in the lower
location.
NOTES:
• If the desired one-touch key location was empty,
the screen will display SAVED! If there is a already
telephone number in it, the screen will display
REPLACE SPD#XX? (XX is the desired one-
touch location number.) You can replace the
current entry by pressing [ENTER], or keep the cur-
rent entry by pressing [ ] or [ ] until you see NO
REPLACE? Press [ENTER]. Then choose another
one-touch key location.
• Only the last number dialed from this extension
can be copied to a one-touch location. The other
numbers in the redial stack cannot be copied.
• Press and hold [ENTER] to exit one-touch setup.