Answering system
NOTE: If the answering system is off and there is an incoming call, the system answers
after ten rings and announces, “Please enter your remote access code.” For more
information about remote access, see page 121.
Call screening
Use this feature to choose whether incoming messages can be heard over
the speaker when they are being recorded. If you turn call screening on, you
hear the incoming message. While monitoring an incoming message, you can
answer the call by pressing HOME/FLASH or /SPEA�ER on the handset,
or HOME on the telephone base.
To change the setting:
Using a cordless handset:
1. When the handset or telephone base is in idle mode,
press MENU to enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press SELECT.
4. Press SELECT to select Call screening.
5. Press qCID or pDIR to choose On or Off.
6. Press SELECT to save the setting. You hear a
confirmation tone.
Answering system settings
106
SELECT
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK
SELECT
CALL SCREENING
On
Off
BACK
To Next Page
Loading...
