AT&T CLP99283 User Manual

Answering system
Answering system settings
Using the telephone base:
1. When the telephone base is in idle mode, press MENU to
enter the main menu.
2. Press SELECT to select Answering sys.
3. Press qCALLER ID or pDIRECTORY to scroll to
Ans sys setup, then press SELECT.
4. Press qCALLER ID or pDIRECTORY to scroll to
Msg alert tone, then press SELECT.
5. Press qCALLER ID or pDIRECTORY to choose On or Off.
6. Press SELECT to save the setting. You hear a confirmation tone.
NOTES:
The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
To temporarily turn off the message alert tone, see page 115.
Recording time
You can set the recording time allowed for incoming messages. The message
length is three minutes by default.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset is in idle mode, press MENU to enter the
main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press SELECT.
4. Press qCID or pDIR to scroll to Recording time, then
press SELECT.
5. Press qCID or pDIR to choose 3 minutes, 2 minutes or
1 minute, then press SELECT to save the setting. You hear a
confirmation tone.
•
•
110
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SELECT
SELECT
ANS SYS SETUP
Remote code
Msg alert tone
Recording time
BACK
SELECT
RECORDING TIME
3 minutes
2 minutes
1 minute
BACK

AT&T CLP99283 Specifications

General

Brand	AT&T
Model	CLP99283
Category	Cordless Telephone
Language	English