Multiple handset use
Intercom
Using the telephone base:
1. Press MENU in idle mode to enter the main menu.
Press qCALLER ID or pDIRECTORY to scroll to Intercom,
then press SELECT.
If you have one handset, the telephone base shows
Calling HANDSET X.
If you have more than one handset, the telephone
base shows INTERCOM TO: Use the dialing keys to
enter a specific handset number (1-9 for handsets
1-9, TONE followed by 0-2 for handsets 10-12, or
TONE followed by # for all handsets), or press
qCALLER ID or pDIRECTORY to scroll to the desired handset and press
SELECT. The telephone base shows Calling HANDSET X or Calling all.
The destination handset(s) rings and shows Base is calling,
BASE 0 is calling or BASE 0 is calling all.
2. To answer the intercom call, press HOME/FLASH, /SPEA�ERSPEA�ER,
CELL 1, CELL 2 or any dialing key (0-9, TONE ) on the destination
handset. Both the base and the handset now show Intercom.
3. To end the intercom call, one party presses END, OFF/CANCEL, or places
the handset back in the telephone base or charger; or presses END on the
telephone base. The other party hears four beeps. Both devices display The other party hears four beeps. Both devices display
Intercom ended.
NOTES:
Before the intercom call is answered, you can cancel it by pressing OFF/CANCELCANCEL on the
handset or END on the telephone base..
If the called device is not answered within 100 seconds, or accessing the directory or caller ID
log, or is on a call, or is out of range, the initiating device shows No answer. Try again.
To temporarily silence the intercom ringer, press OFF/CANCEL or MUTE/DELETE on the
handset, or press CANCEL or MUTE on the telephone base.
You can only use one pair of devices at a time to make intercom calls.
•
•
•
•
•
•
69
Answering sys
Directory
Caller ID log
Intercom
p
q
SELECT
BACK
INTERCOM TO:
HANDSET 1
HANDSET 2
All
p
q
SELECT
BACK
To Next Page
Loading...
