Multiple handset use
74
Push-to-talk (PTT)
PTT call to a single device
Using a cordless handset:
1. There are a few ways to begin a PTT call to a single device. When the
handset is not in use:
If you have one handset, press and hold PUSH TO TAL�.
If you have more than one handset:
w Press PUSH TO TAL� on the handset, then use the dialing keys to
enter the destination device number.
-OR-
w Press PUSH TO TAL� on the handset. Press qCID or pDIR to highlight
the destination device number, then press SELECT or PUSH TO TAL�.
The handset shows Connecting to HANDSET X...
(HANDSET represents
the handset name, X represents the destination handset number) or
Connecting to BASE 0... (BASE represents the base name)
for a few
seconds. When the connection is made, both your and the destination
device screens display Press and hold [PTT] to talk.
2. Press and hold PUSH TO TAL�. A chirp indicates your microphone is on.
Speak towards the device. Your voice is broadcast to the destination device.
While you are speaking, your handset shows PTT To HANDSET X or
PTT To BASE 0.
3. Release PUSH TO TAL� after speaking. Both devices beep once again and
the screens show Press and hold [PTT] to talk, then you can
press and hold PUSH TO TAL� to continue speaking or the destination
device can respond (see Answer a PTT call on page 78).
4. To end the PTT call, press OFF/CANCEL or END, or place the handset in
the telephone base or charger. The handset shows Push to talk ended.
NOTE: After PUSH TO TAL� is released, the PTT call remains open for a short time. If no
one presses PUSH TO TAL� within 10 seconds, the PTT call ends automatically.
•
•
To Next Page
Loading...
