Bluetooth
Bluetooth setup
7. When the screen displays the found devices, press
qCALLER ID or pDIRECTORY to highlight your headset if
necessary, then press SELECT.
Enter the PIN of your headset if required. The PIN
for most Bluetooth devices is 0000 (refer to the
user’s manual of your headset), then press NEXT.
8. The screen displays Adding Headset A when the base
is connecting to your headset.
9. When a device is successfully connected, the
telephone base displays Headset A is added and connected to base
and the corresponding status icon 2. You hear a confirmation tone. The
corresponding light on the telephone base CELL 2/HEADSET turns on.
If you have trouble pairing your headset, it may not be compatible
with your CLP99183/CLP99283/CLP99353/CLP99383/CLP99453/
CLP99483/CLP99553/CLP99583. Check the Bluetooth compatibility list
at www.telephones.att.com/bluetooth.
NOTES:
The pairing process may take up to one minute. If the pairing process fails, try again.
When a connected headset is charging, it may disconnect from the telephone base and the
CELL 2/HEADSET light on the telephone base turns off. For some headset models, you may
need to turn on the headset and reconnect it to the telephone base again.
•
•
•
Adding
Headset A
Headset A
is added
and connected
to base.
23
To Next Page
Loading...
Need help?
General
