AT&T Small Business System Speakerphone - TELEPHONE OPERATION (continued); Redial Stack; Auto Redial

Make or Answer a Call
continued from page 43
Headset
You can use this phone hands-free when you install any
industry standard two-band 2.5mm headset (purchased
separately). For best results use an AT&T two-band
2.5mm headset.
Make sure the headset is plugged into the headset jack.
You will hear a double-beep if you press h when
the headset is not plugged in.
¥
NOTE: If headset is programmed as the default mode,
(see “Set Automatic Mode” on page 33) but the
headset is not plugged in, the phone will switch to
speakerphone.
To make a call, press and release h or press
the desired LINE button and then press h. The
HEADSET light goes on. Wait for a dial tone, then dial
the call. Press h to end the call.
To answer a call, press h. Press h
again to end the call.
¥
NOTE: If speakerphone is programmed as the default
mode (See “Set Automatic Mode” on page 33), you
must press h to activate the headset.
44
TELEPHONE OPERATION
TELEPHONE OPERATION
i
ii
iii
ii
iii
ii
iii
ii
ii
k
k
k
974_CIB_1ATT_FINAL 4/9/2004 3:32 PM Page 44