ATCOM AT-610 - Stun

AT-610 User Manual
ATCOM TECHNOLOGY CO. , LIMITED
Notice
Notice
Notice
Notice ： The above configuration can exist at the same time. For example you
enable # as the signal of sending the call while set fixed length of 11. Either you
press # before the number reach 11 or dial 11 digital can send out the call
4.3.
4.3.
4.3.
4.3. Stun
Stun
Stun
Stun
 STUN NAT Transverse ： STUN NAT Transverse status true or false

STUN Server Addr: configure stun server address;

STUN Server Port: configure stun server port default 3478

STUN Effect Time: stun detect NAT type interval time .If NAT found a link
inactive for a certain time , it will close the link so you need to send a packet
within a interval tome to keep the link alive
 Local SIP Port ： config local SIP port , default as 5060Use Stun ：
enable/disable SIP STUN
Notice:
Notice:
Notice:
Notice: SIP STUN is used for NAT transverse. When you config STUN
server ’ s address and port (default 3478) and enable it, then you can use the
normal SIP server to make the IP phone transverse NAT .