Atel Arch W01 - MAC Address Filtering; MAC Filter Operation

Mac Filter
The default “MAC Filter” status is “OFF”. If the MAC Filter is on and devices are listed in MAC
Address Filter list, then all of the listed devices will be able to connect to your W01 Arch.
For any given device, the interaction of the MAC Filter with the “Block” feature on the Connected
Devices screen is shown on the following table.
Included in Block List
Included in MAC
Filter List
Connection
No
Yes
Allowed
No
No
Not allowed
Yes
Yes
Not allowed
Yes
No
Not allowed
The “Block” (Blacklist) feature is always available. After blocked, the blocked devices will disconnect
from the W01 Arch.
Because enabling the MAC Filter could potentially disconnect all devices, the user needs to
populate the “MAC Address Filter” list first while the MAC Filter is OFF. Otherwise when you click
the “ON/OFF” button, it will prompt warning information as follows: