ATEQ VT67 - 8.3 COPY

Pg. 17
8.3 COPY
CopyallowsyoutocopytheIDfromanexisngsensor,andpasteittoablankaermarketsensor.
1 2
First,selectCopyfromtheProgram
menu.
Placetheoriginalsensorabovethetool’santennaandselectCopy.You
canalsocopythesensorIDfromtheoriginalsensorifitissllinstalled
inthewheel.
OR
3
TheoriginalsensorIDwillbe
displayed.SelectProgramCopiedID.
4
Placethenewsensorabovethetool’santennaandselectProgram
CopiedID.AerafewmomentsthenewsensorIDwillbedisplayed
andthesensorwillbesuccessfullyprogrammed.