ATEQ VT67 - 8.7 RETRIEVE ID

Pg. 22
8.7 RETRIEVE ID
1
First,selectRetrieveIDfromthe
Programmenu.
3
Aerafewmoments,thetoolwill
displayachartofthecurrentsensor
IDsstoredineachwheel
RetrieveIDallowsyoutoretrievethesensorIDsthatarecurrentlystoredinthevehicle’sECUandprogramthemto
blankaermarketsensors.
2
Then,connecttheOBDIIQuickConnectCableintothetoolandtheninto
thevehicle.Onceconnected,selectRetrieveIDs.
4
Placetherstsensorabovethe
tool’santennaandpresstheProgram
buon.
5
Aerafewmoments,thesensorwillbe
successfullyprogrammedandwillnow
havethesameIDasthestoredID.
a
B
6
Repeatstep5fortheremaining3
sensors.