ATEQ VT67 - 8.4 CREATE SET

Pg. 18
8.4 CREATE SET
1
First,selectSetfromtheProgram
menu.
4
Placetherstsensorabovethe
tool’santennaandpresstheprogram
buon.
CreateSetallowsyoutoprogramnewIDsto4blankaermarketsensorsallonthesamescreen.
2 3
Then,selectCreateSet. Thetoolwilldisplayachartwith4
wheelsandaprogrambuonfor
each.
5
Aerafewmomentsthesensorwill
besuccessfullyprogrammedandthe
toolwilldisplaythesensor’sID.
6
Repeatstep4fortheremaining3
sensors.