26
Important!
First connect the fixture to the external LED power supply before connecting the power
supply to the mains.
3.2. Mounting the fixture
For the two suspensions, drill two holes in the ceiling at the distance of the ropes (440
mm).
Mounting aids such as dowels, screws, etc. ... are deliberately not included in the scope
of delivery. These must be selected according to the local ceiling conditions.
Consult a specialist dealer for advice on the fasteners to be selected. After the wire sus-
pension has been attached successfully, the fixtures can be suspended using the Y-
mounting.
Important!
The Y-ropes must be inserted into the sleeve of the holder so that they are clearly visible
on the underside of the fixture. Then check that the ropes are firmly connected to the
bracket.
The ropes can be removed by pressing the sleeve of the bracket.
The power supply and the fixture become warm during operation. Ensure that sufficient
heat dissipation is ensured. Do not place any objects on the fixture.
To Next Page
Loading...
Need help?
General