ATI Technologies Straton - 4 Connection of the Straton to a Terminal Device; Connecting Via W-Lan;Wireless Network; Connecting Via Ethernet Cable (Alternative to W-Lan;Wireless Network)

27
4. Connection of the Straton to a terminal device
4.1. Connecting via W-Lan/wireless network
After the fixture has been connected to the mains, it takes 2 -
3 minutes for the contro
ler of the fixture to set up a WLAN network. You can then access the controller with any
WLAN-enabled device. E.g. with a Windows laptop:
Use your preferr
ed Internet browser and enter the IP address of the fixture
(192.168.100.1).
Sign in.
The user ID for the factory setting is "admin" and the
corresponding password is also "admin".
Your browser opens the control interface with the factory
settings of your fixture.
The system time of your PC or platform-
independent terminal device is also transferred
to the fixture.
4.2. Connecting via Ethernet cable (alternative to W-
Lan/wireless network)
Connect the power supply unit to your PC or platform-
independent
commercially available Ethernet cable (not included in the scope of delivery).
Use your preferred Internet browser and enter the IP addres
(192.168.100.1).
Sign in.
3 minutes for the contro
l-
ler of the fixture to set up a WLAN network. You can then access the controller with any
ed Internet browser and enter the IP address of the fixture
independent terminal device is also transferred
Lan/wireless network)
independent
end device using a
commercially available Ethernet cable (not included in the scope of delivery).
Use your preferred Internet browser and enter the IP addres
s of the fixture