BLM 3750 User Guide Curves Viewer
9836 3078 01 Edition 2.0 47 (78)
Reset the zoom function and display the whole curve.
Click to change the filter parameters:
Click on Edit to change the default cut frequency.
In the box at the top of this window choose between a filter of the third or fifth order.
Changing these parameters affect the filtered curve (shown in black), and not the
unfiltered curve (shown in green)
It is possible to shown automatically the curve after each test, by enabling the Debug Mode.
Select the Test Setup menu:
This menu can be accessed by a proper bench administrator password, provided with the test bench
documents delivered with the bench.
Select the folder Advanced Settings, and the following window is shown.
To Next Page
Loading...