Atlas Copco BLM 3750 - APPENDIX A: Tool Testing Guidelines; Overview of Tool Testing

BLM 3750 User Guide Appendix A: Tool Testing Guidelines
9836 3078 01 Edition 2.0 65 (78)
11 APPENDIX A: Tool Testing Guidelines
This chapter gives an overview of the tool testing guidelines.
The BLM 3750 features 2 different type of test:
• Statistic control test (when used with Torque Supervisor)
• Cm-Cmk test
Normally, here is the way in which the tool testing in managed:
The Statistic Control, which involves few tests on the tool, can be quickly run every day in order to check
the tool before starting the working shift. The full set of tests performed by the Cm-Cmk test takes longer,
and it is usually run on the tool with a lower frequency; it is required anyway for a tool coming from a
repair or calibration operation.
Test Cm-Cmk
Tool in use on the
line
Periodic statistic
testing in few seconds
Repair or adjust the
tool
Not OK
OK