Executing a Free Test BLM 3750 User Guide
38 (78) 9836 3078 01 Edition 2.0
4.2.1 Impulse tools test setup
The test parameters for Impulse tools can be customized in the Test Setup menu:
This menu can be accessed by a proper bench administrator password, provided with the test bench
documents delivered with the bench.
Cut-off frequency (Hz)
The filter frequency is applied to the samples measured by the torque transducer to filter the noise. The
default value is 2000 Hz.
Time out (ms)
This parameter determines the end of the test. When the torque goes under the transducer minimum load
and remains under that value for the given Time out, the test ends. The Time out is given in milliseconds.
The default value is 500 ms.
To Next Page
Loading...