Working with Torque Supervisor BLM 3750 User Guide
52 (78) 9836 3078 01 Edition 2.0
When exchanging data with Torque Supervisor Full, the bench must be connected to the network (it can
be disconnected then for test execution), and FTP Server Bench must be always running on the bench:
Do not disable the application.
For the installation details of Torque Supervisor and Torque Supervisor Client, refer to the specific
software manuals. The bench data (either for local bench with Torque Supervisor Full or remote bench
with Torque Supervisor Client) must be also set inside the software.
Certain special screens are used when a test is launched from Torque Supervisor (Full, Light and Client).
All of the test parameters are sent by Torque Supervisor; the bench executes the test and sends the results
to Torque Supervisor, when required.
The tests are run in the same way when launched from the bench or from Torque Supervisor; refer to the
previous chapter for testing philosophy.
When a Cm-Cmk test is executed, the following screen is shown:
To Next Page
Loading...