Working with Torque Supervisor BLM 3750 User Guide
54 (78) 9836 3078 01 Edition 2.0
When a statistic control test is run, the following window is shown:
Once the specified number of tests for the statistic control has been completed, the result is displayed.
If the result is not OK, one or more messages describing the type of non-compliance are displayed in red.
NOTE: The result of a test is closely related to the settings of the statistic control rules. These
rules are defined in the BLM software settings and they may be customized according to the
customers’ needs during the bench startup process.
The result shown in the test window is calculated applying the bench rules, and not the Torque
Supervisor rules.
To maintain consistency between the two programs, the rules must be set in the same way. If not,
same test values may give a different OK / Not OK result on the bench or in Torque Supervisor.
Refer to the Torque Supervisor user guide
to see how to change the rules in Torque
Supervisor.
message(s)
To Next Page
Loading...