Working with Torque Supervisor BLM 3750 User Guide
60 (78) 9836 3078 01 Edition 2.0
If the new calibration value is almost the same of the previous one, the tool is considered as already
calibrated. A warning message asks the user to send anyway the new coefficient or keep the actual one.
The percentage of the coefficient variation for which the tool must be considered already calibrated is also
defined inside Torque Supervisor.
Click on Discard if the new value is not acceptable. The following window is shown:
Specify the reason:
• The tool is already calibrated: The calibration test is considered as OK in Torque Supervisor.
• The coefficient is out of range: The calibration test is considered as Not OK in Torque
Supervisor.
• Unspecified: Other reasons.
To Next Page
Loading...