FlexiROC T30 R 4 Safety Precautions
16 No: 3133793291.1.3133851403 en-US
n Always use protective safety glasses when using a hammer, as chips or debris can
cause eye injury.
n Use a hammer with a soft face when driving hardened pins.
n Use a respirator in dusty conditions.
n Make sure that compressed air for cleaning the machine does not exceed 2 bar (30
psi).
n Wear protective face shield and clothing when cleaning with compressed air.
4.3 Safety During Lifting, Installing, and Connecting
Make sure that the following conditions are met while lifting, installing, and connecting the
machine or its equipment:
n Make sure only authorized personnel lifts, installs, and connects the equipment.
n Use lifting devices for lifting heavy components.
n Use only approved tools and methods.
n Use lifting devices that are inspected and approved, and are in compliance with local
regulations.
n Attach lifting devices only to specified lifting points.
n Make sure that no personnel is present under suspended loads.
n Use only ladders and platforms designed for that specific purpose.
4.4 Safety Precautions During Tramming
n Follow local traffic regulations.
n Observe that no personnel is present within the machine hazard zone or in the direc-
tion of travel.
n Be aware that impaired visibility can cause a collision risk for the operator and for other
machines.
n Always check the ground conditions where the machine will be operated.
n Adapt the speed to the terrain.
n Never exceed the maximum allowed inclination angles for the machine.
n Make sure that the boom system is set to the correct tramming position.
4.5 Safety Precautions During Operation
n Check that pedals and controls are easily accessed by the operator, before starting the
machine. If the controls are not accessible to the operator, the machine must not be
operated.
n Make sure that all warning signals on the machine are tested by the operator before
starting the machine (for example, brake lights and turn signal).
n Keep all doors closed during operation to not disrupt the flow of cooling air or reduce
noise suppression. A door may be kept open for a short period, only if necessary.
n Turn the rotation off when manually handling drill bits and drill steel.
n Activate the machine functionality of collecting dust (water flushing, water mist, or dust
collector) during drilling. Rock dust is created during the drilling process and is harmful
to the health.
n Stay clear from the exhaust cleaning unit and the exhaust pipes on exhaust openings.
High temperature gases escape from the unit.
n Switch off the diesel engine before refueling. Do not handle flammable liquids near hot
surfaces, sparks, or a naked flame.
To Next Page
Loading...
Need help?
General
