To Next Page

To Previous Page

FlexiROC T30 R 5 Safety Functions

22 No: 3133793291.1.3133851403 en-US

NOTE: Disable the automatic fire suppression system when steam-cleaning, hi-pres-

sure washing, welding, battery charging and starting with auxiliary battery.

To disconnect the automatic fire suppression system, remove fuse FSB1 located near the

battery. Check all electrical functions when work is done.

The fire fighting system suppresses fire over the following areas:

n Over and around the engine

n Over and around the fuel tank

Large quantities of flammable materials cannot be suppressed by the automatic fire sup-

pression system. Use other methods to suppress residual fires.

See Reference Documentation

OEM instructions for automatic fire suppression system

5.3.3 Description of Fire Extinguishers

Make sure that the machine is equipped with approved portable fire extinguishers in accor-

dance with the local regulations and laws that apply. The machine is equipped with desig-

nated locations for the fire extinguishers.

Class Type of Fire

A Fires of common materials that burn with both

flames and glow (for example, most interior mate-

rials)

B Fluid fires such as gasoline and oil

C Gas fires

Table1: Classification of Fires

Follow the instructions on the fire extinguisher.

5.3.4 Location of Fire Extinguishers

NOTE: If the fire extinguisher has been used then, it must be replaced with a new one

immediately.

Atlas Copco FlexiROC T30 R Safety

Other manuals for Atlas Copco FlexiROC T30 R