FlexiROC T30 R 10 Environmental Protection
40 No: 3133793291.1.3133851403 en-US
A worn out machine must be handled and disposed of in such a way that maximum per-
centage of the material can be recycled. The negative impact on the environment must be
as low as possible. If the end user has inadequate knowledge about disposal, a locally-au-
thorized disposal company should be hired.
The following points should be considered during disposal of the machine:
n All steel structures, copper and aluminum in electrical cables can be recycled.
n Make sure that fluids are drained and filters removed. Handled in accordance with lo-
cal regulations.
n Most plastic parts are recyclable. Check the material type and date marked on each
plastic part to determine if that part can be recycled.
n Rubber parts are not considered as hazardous waste and can be disposed off accord-
ing to local regulations. Hydraulic hoses must be cleaned before they can be disposed
off.
n Electrical components, such as batteries and circuit boards, must be taken to an ap-
proved electrical recycling facility.
n Air conditioning equipment must be taken to an approved recycling facility.
n The windscreen and other cabin windows must be disposed of as waste, not as normal
glass recycling.
To Next Page
Loading...
Need help?
General
