10 Pressure equipment directives
PED instructions GA90 up to GA160
Product : GA90-160
This machine is a pressure assembly of cat. III according to 97/23/EC.
Parts of article 3.3 of 97/23/EC are subject to good engineering practice.
Parts of category I according to 97/23/EC are integrated into the machine and fall under the exclusion of article
I, section 3.6.
Parts subject to the Simple Pressure Vessel Directive 87/404/EEC are excluded from 97/23/EC according to
article I, section 3.3.
The following pressure bearing parts are of category higher than I :
Oil separator vessel : Cat III
For GA 90 and GA 110: design pressure 15 bar(e), content 147 l
For GA 132 and GA 160: design pressure 15 bar(e), content 189 l
Design standard : ASME section VIII div. 1.
Safety valve : Cat IV
Design code : AD-Merkblätter, A2
PED instructions GA200 up to GA500
Product : GA 200-500
This machine is a pressure assembly of cat. IV according to 97/23/EC.
Parts of article 3.3 of 97/23/EC are subject to good engineering practice.
Parts of category I according to 97/23/EC are integrated into the machine and fall under the exclusion of article
I, section 3.6.
Parts subject to the Simple Pressure Vessel Directive 87/404/EEC are excluded from 97/23/EC according to
article I, section 3.3.
The following pressure bearing parts are of category higher than I :
Oil separator vessel : Cat IV
For GA 200, GA 250 and GA315 60Hz, 1 vessel: design pressure 15 bar(e), content 305 l
Design standard : ASME section VIII div. 1.
Safety valve : Cat IV
Design code : AD-Merkblätter, A2
Instruction book
2920 1475 06 129
To Next Page
Loading...
