- 48 -
5.4.2.2 Changing the engine oil
1. Start the engine and let it run for a while to warm
up.
2. Stop the engine.
3. Remove the plug (1) from the oil drain hose (2).
4. Blow the oil filter with clean air (see chapter
“Cleaning the oil filter”)
5. Reinstall the plug (1) with a new sealing washer
and tighten it.
6. Pour in engine oil.
5.4.2.3 Cleaning the oil filter
1. Loosen the fixation bolt (1).
2. Remove the oil filter (2) from its housing.
3. Blow out the oil filter (2) with compressed air,
from the inside to the outside.
4. Replace the upper gasket (4) and slightly oil the
upper and lower gaskets (3, 4) before reinstalling
them.
5. Reinstall the oil filter (2) and tighten the fixation
bolt (1).
00_00_HiLight H5+-H2_EN.book Page 48 Thursday, February 27, 2020 3:23 PM
To Next Page
Loading...
