Product information EN MT Focus 6000
6
© Atlas Copco Industrial Technique AB - 9839 0470 01
Compatible tools
MT Focus 6000 is compatible with the following tools:
• ETD M xxx V2
• QMC 21
• QMC 41
The tool must be calibrated for running with MT Focus 6000.
Normal environmental conditions
This product is designed to be safe under the following conditions:
• Indoor use
• Altitude up to 2 000 m
• Temperature 5 °C to 40 °C
• Maximum relative humidity 80 % for temperatures up to 31 °C decreasing
linearly to 50 % relative humidity at 40 °C
• Mains supply voltage fluctuations up to ±10 % of the nominal voltage
• Transient overvoltages up to the levels of overvoltage category ll
• Temporary overvoltages occurring on the mains supply
• Pollution degree 2
Service overview
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed
information on preventive maintenance. If the product is not working properly,
take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow
these general guidelines:
• Clean appropriate parts accurately
• Replace any defective or worn parts
To Next Page
Loading...
