Power Focus 600 EN
© Atlas Copco Industrial Technique AB - 9836 4954 01
3
Functionality Joint control Station control
Pset 1 16
Results 30 1000
Events 1000 1000
Batch — Batch sequence – Configure up to
four batch sequences. (1 batch se-
quence = 8 batches x 99 tighten-
ings)
Accessories No external hardware accessories
can be connected or configured.
The following external hardware
accesories can be connected and
configured:
• I/O Expander
• Stacklight
• Operator panel
• Socket selector
• Scanner
QIF accessories
The Power Focus concept features a number of accessories that simplify the
guidance and follow-up of performed tightenings. To use accessories with the
Power Focus a Station control IAM is required. The accessory functions can
be set up from the Accessories menu on the Power Focus unit.
The benefit of using serial bus-based accessories (I/O bus) is that they can be
connected in series, from accessory to accessory rather than hard wiring each
accessory to the Power Focus. This arrangement increases flexibility and quick
installation.
Power Focus uses 24 V DC, 1.5 A to power the bus, which is also used to
power external I/Os. If more current is needed, the bus must be powered exter-
nally. Every device has a 24 V DC input for this purpose.
Note! For further information about the accessories, refer to each accessory’s
user guide.
I/O Expander, sealed
I/O Expander enables the connection of several in-
puts and relays when more than those built-in are re-
quired. There are eight digital inputs, and four digital
and four relay outputs with the same functionality as
the four built-in I/Os. Each input and relay can be
configured individually.
The sealed I/O Expander is designed for more de-
manding environments than I/O Expander.
To Next Page
Loading...
