Power Focus 600 EN
© Atlas Copco Industrial Technique AB - 9836 4954 01
5
Tool information
The Tool information view contains information used for giving service person-
nel accurate information about the tool connected to the controller so that they
give adequate help and support or for operators to see what tool is connected to
the controller.
Note! A tool must be connected to the controller for the
Tool menu to show information.
On the Tool menu, go to Tool information.
Information Description
Model Tool model denomination.
Max torque The maximum torque the tool is able to produce. This
value is used to calculate the tightening parameter
values depending on Tool max torque.
Max speed The maximum speed the tool is able to produce. This
value is used to calculate the tightening parameter
values depending on Tool max speed.
Gear ratio The ratio of the angular velocity of the input gear to
the angular velocity of the output gear.
Serial number The tool’s serial number can be needed when the cor-
rect version of the Product instruction is required, in
order to get the correct spare parts or service instruc-
tions.
Software version Tool software version.
Product number The tool’s Product or Ordering number.
Software information
The Software view contains information used for giving service personnel accu-
rate information about the software installed on the controller so that they give
adequate help and support, and an option to update and activate the controller
software.
To Next Page
Loading...
