Atlas Copco POWER FOCUS 6000 Product Instructions

Service EN POWER FOCUS 6000
16
© Atlas Copco Industrial Technique AB - 9836 6528 01
Warning! Do not use a power supply with galvanic isolation, since it disrupts the function of the residual-
current circuit breaker with overcurrent protection (RCBO device). The test button for the RCBO device
activates the RCBO device, even if the power supply is from an isolated transformer.
Warning! If the power cable needs to be replaced, only use a genuine Atlas Copco replacement power ca-
ble. Use of a non-genuine power cable may result in dangerous situations.

Atlas Copco POWER FOCUS 6000 Specifications

General

Model	POWER FOCUS 6000
Category	Controller
Connectivity	Ethernet, USB
Supply voltage	100-240 V AC
Frequency	50/60 Hz
Fieldbus protocols	PROFINET, EtherNet/IP
Data storage	Internal memory
Operating temperature	0°C to +45°C
Storage temperature	-20 to 70 °C
Relative humidity	90% (non-condensing)