Atlas Copco POWER FOCUS 6000 Product Instructions

Installation EN POWER FOCUS 6000
12
© Atlas Copco Industrial Technique AB - 9836 6528 01
Pin Use
1 Do not use
2 Do not use
3 Do not use
4 Do not use
5 Do not use
6 Do not use
7 Do not use
8 Do not use
9 Do not use
10 Do not use
Last controller
EM Stop I/O cable connector: Phoenix, 10-pin
Use the following pin configuration:
Pin Use
1 Do not use
2 Do not use
3 Do not use
4 Do not use
5 Do not use
6 Do not use
7 Do not use
8 Do not use
9 Connect a jumper between pin 9
and pin 10
10 See pin 9
Resetting the Emergency Stop
Resetting an activated emergency stop is done by the software.
QST Cable
QST spindles can be used in combination with the Power Focus 6000. The QST types approved to be
compatible with the Power Focus 6000 are: QST 34/42/50/62.
Requirements
Minimum bending radius
Cable type Minimum bending radius
QST cable 5x cable diameter
Maximum cable length
Tool type Recommended max cable length [m]
QST 34/42/50/62 60 m (3x20m OK, 6x10m NOK)
Cable extensions

Atlas Copco POWER FOCUS 6000 Specifications

General

Model	POWER FOCUS 6000
Category	Controller
Connectivity	Ethernet, USB
Supply voltage	100-240 V AC
Frequency	50/60 Hz
Fieldbus protocols	PROFINET, EtherNet/IP
Data storage	Internal memory
Operating temperature	0°C to +45°C
Storage temperature	-20 to 70 °C
Relative humidity	90% (non-condensing)