- 21 -
3.4 Electrical features
The electrical features described in this chapter are
standard provided on this compressor.
3.4.1 User Interface and Compressor
Control Module
General description of the User Interface
The User Interface consists of a color LCD display
which gives the user the essential process information
feedback.
Any mix-up of buttons and button functions is
reduced to an absolute minimum thanks to an
ergonomic design, which has as few buttons as
possible.
The User Interface is built in into the side of the rear
right corner panel, with an emergency stop button
directly underneath, for maximum safety during the
cranking procedure.
3.4.2 Indicator lamps
1 Running hours and warning bar. When warnings
occur, they swap with the running hours on this
bar, showing the next message every 3 seconds.
2 Setpressure bar
3 Additional information bar
4 Compressor status bar
5 Button function bar
6 Air discharge pressure and shutdown information
bar
7Fuel bar
8 This is what the fuel level bar would look like if
you hook up external fuel supply.
1
3
45
7
6
8
2
1 Stop lamp
2 Warning lamp
3 Maintenance lamp
4 Wait-to-Start lamp
To Next Page
Loading...
