- 33 -
5.2 Operating
5.2.1 Starting
– Move the control panel power switch to ON. The
display of the User Interface will light up. See also
chapter 5.3.
– Use the arrow keys to set the working pressure.
– Push the start button on the panel. The horn will
sound.
The compressor can be loaded after the warmup
period.
• Manual: push the button below the indication
LOAD, in the display.
• Automatic: the compressor will load
automatically when the button below the
indication AUTO LOAD, in the display, is
pushed during the warmup period.
The unit will LOAD/UNLOAD according to the
air demand.
– Open the air outlet valve(s).
When the unit is in the standby status for a long time,
the following action should be performed:
– Without application: turn OFF the battery switch.
– Running: supply power to the battery conditioner.
5.2.2 During operation
Regularly carry out following checks:
– Check alarm lamp at the front and alarm lamp and
horn at the back of the unit.
When starting up the unit and also when a
shutdown occurs, the alarm lamps and the horn
will be activated. But when a warning occurs, only
the lamps will be activated.
– Check the air filter service indicator.
If the yellow signal shows in the window of the
indicator (see section 6.4.2.3), clean or replace the
filter elements.
– Check the air outlet temperature of the MP
compressor element.
5.2.3 Stopping
– Close the air outlet valve(s).
– On the User Interface, push the function button
below the indication Noload.
– Push the Stop button.
– Once the engine has stopped, switch the control
panel power switch to the OFF position.
– Turn OFF the battery switch
Make sure that nobody is in the unit
and all doors are closed prior to
starting the unit.
The start/stop instructions are
available in different languages on
request.
The pressure is not immediately
relieved from the unit, when the
Stop button is pushed.
To Next Page
Loading...
