- 48 -
5.4.14 System info status
This status gives a summary of the following
parameters:
– Unit Type
– Unit Serial Number
– Engine Serial Number
– Fleet Number
– Maximum Setpressure
– Minimum Setpressure
–Maximum Set RPM
– Unload pressure
– Reload pressure
– Output Code: This code is directly proportional to
the Maximum set RPM, and gives a rough
indication of the maximum Free Air Delivery
(FAD) with the current setting.
– Active Control Mode: Local control; Remote
control; PC control.
– Air Inlet Temperature
– Battery Voltage
– Software version UI
– Software version CCM
Other actions and signals have no effect in this status.
5.4.15 Options status
In this status, the operator can change the parameters
for which he has clearance.
The Rental companies can deny access to the gray
parameters for the operator.
In that case, the parameters are not shown on the
screen.
With the arrow buttons, a parameter is selected.
Parameters which toggle between different settings
(e.g.: Pressure Units), can be changed by pressing the
Toggle button.
Other parameters (e.g.: Display Luminosity) can be
changed by pressing the Edit button.
After changing the value with the arrow buttons, the
new value needs to be confirmed with the OK button.
A ↓-button, press once R Set pressure - 0.1 bar
A
↑
-button, press once R Set pressure + 0.1 bar
A Return button R To Ready for Start status
(see section 5.4.2)
A Options button R To options status (see
section 5.4.15)
A Emergency stop button R To emergency stop status
(see section 5.4.13)
A Power OFF switch R End of operation
A Return button R To Ready for Start status
(see section 5.4.2)
To Next Page
Loading...
