- 18 -
Following LEDs are used on the
Qc1002™
Qc1002™ Menu Overview
At Qc1002™, the LCD will show following
information:
–in Normal condition (scroll through the
information using UP and DOWN):
• Status (eg: preheat, crank, run, cooldown,
extended stop time, …)
• Controller type & version
• Parameter list
•Alarm list
• LOG list
• Service Timer 1 & Service Timer 2
• Battery Voltage
• Coolant temperature
• Oil pressure
•RPM (speed)
• Fuel level
• Voltage - frequency - running hours
–in Alarm condition (scroll through the
information using UP and DOWN):
• a list of all active Alarms
It's possible to scroll through the views, using the UP
and DOWN buttons. The scrolling is continuous.
If a Special status comes up, the Status Display is
shown.
If an Alarm comes up, the Alarm Display is shown.
START: Is used to start the unit in
Manual Mode.
STOP: Is used to stop the unit in
Manual or Remote Mode (always
with shutdown!). When the unit is
stopped with the STOP button in
Remote mode, it will automatically
go to Manual Mode.
Power Green LED indicates that the unit is
powered up.
Remote Green LED indicates that the Remote
Mode is selected.
Start/Stop Green LED indicates that the engine
is running.
Alarm Flashing red LED indicates that an
alarm is present. A continuous red
LED indicates that the alarm has been
acknowledged by the user. The exact
alarm is shown on the display.
Remote
Power
Alarm
Start/Stop
Qc1002 CAN
145
To Next Page
Loading...
