On the road -
_______________ __.
In this case the braking power of the parking brake may not be
adequate
to prevent the vehicle from rolling unintentionally.
Please release parking brake
Please note that for safety reasons the parking brake is released auto-
matically only if the driver's seat be lt is fully engaged in the buckle.
To release the parking brake press the brake pedal
This driver message appears when the switch to release the parking
brake was pressed. The parking brake can only be released if you step
on the brake pedal and at the same time press the switch or you auto-
matically release the parking brake w it h the starting assist
==> page 109.
' Parking brake!
This driver message appears together with the yellow , symbol
when there is a parking brak e malfunction.
Malfunction starting assist
Th is dr iver message appea rs if there is a starting assist malfunction.
The automatic release of the parking brake when starting is malfunc-
tioning. You have to release the parking brake manually by press ing
the switch. Have the problem corrected by an authorized Audi
dealer. •
Cont rols and equip-
ment
Vehicle OP-eration
Cruise control
Switching on
The cruise control system makes it possible to drive at a
constant speed starting at 20 mph (30 km/h).
A ,.....__
Fig. 104 Control lever
with push-button
Fig. 105 Display:
Selected speed
- Pull the lever to position © ==> fig . 104 to switch the
system on.
- Drive at the speed to be controlled.
- Press button @ to set that speed.
The stored speed and the green symbol (CRUISE (US model)/ 0'
(Canadian model) are shown in the display => fig. 10S. The display _.,
Vehicle care Do-it-yourselt service iTechnical data
To Next Page
Loading...
