Audi A4 2010 - Storing and Recalling Settings

to be used temporarily by a driver whose settings are not going to be
sto red. •
Applies to vehicles : with sea t me mory
Storing and recalling settings
Before you can store or recall your settings, the [ ON/OFF]
switch on the seat memory must be engaged (not raised).
Storing settings
- Adjust the driver's seat.
- Adjust the two exterior mirrors .
- Press the
I SETI button and hold it down. In addition, press
one of the memory buttons for at least one second .
- Release the buttons. The settings are now stored under
the corr esponding memo ry button .
Recalling settings
- If the driver's door is open, tap the corresponding memory
button briefly .
- If the driver's door is closed , press the appropriate
memory button unt il the stored position is reached .
Successfu l storage is confirmed audib ly and by the light in the [SET )
button illumi nat ing=> page 72, fig . 67 .
When the vehicle is
locked, the curren t settings are stored and
ass igned to the remote contro l key. But the setti ngs sto red on
memory but t ons 1 to 2 are not deleted . They can be reca lled at any
time. When the vehicle is
unlo cked, the settings stored on the
remote control key are restored .
If your vehicle is driven by other persons using your remote control
key, you should save your individua l seat position on one of the
Controls and equip -
ment
Safety first
Se ats and storage
memory buttons. You can recall your settings again simp ly and
conveniently by press ing the cor responding memory but t on. When
the vehicle is locked, these settings are automat ically re-assigned to
the remote control key and stored.
& WARNING
• Fo r safety reaso ns, the se at se tting can only be recalled when
the ve hicle is stat ionary - oth erwise you risk having an accident .
• In an emergency th e recall procedure can be cancelled by
pressing the [
ON/OFF) switch or by tap ping of t he the memo ry
butt ons. •
Applies t o vehicles: wit h seat me mory
Activating remote control key memory
To be able to recall the stored settings with the remote
control key, the function has to be activated in the radio
orMMI*.
- Select : Function button I CAR]> Seat adjustment >
Driver's seat > Key mem . profile > On.
(I) Tips
If you do not want another driver to store their settings on the
remote key, switch off the Memory function using the radio or MMI*
or the [
OFF) button => page 72 . •
Vehicle care Technical data