____________________________________________ A_ d_a___,_p_t_i_v_e_ c_r_u_i_s_e_ c_o_n_ t _r_o_l _ __.fflll
Appli es to vehicles: with adapt ive cruise contro l
How is the speed stored?
Fig. 109 Control
leve r: St oring speed
With th e sys t em switched on the speed is stored as follows:
- Drive at the speed you want . The speed must be between
20 and 95 mph (30 and 150 km/h) .
- Press the
!SETI button ~ fig . 109 to store the desired
speed .
After the ( SET I button is released, the current speed is stored and
maintained .
The saved speed is now shown in th e LED display in the speedom et er
by one or two illuminated red light diodes=>
page 121 . At the same
time, the saved speed is also shown fo r a short time in the Info rma-
tion line~
page 123.
(I) Tips
For safety reasons, the stored speed is deleted when the ignition is
turned off . •
Cont rols and equip-
ment
Vehicle OP-eration
Appli es to vehicles : w ith adapt ive cru ise cont rol
Changing stored speed
The speed can be changed without touching the acceler-
ator or brake pedal.
Increasing speed
,...
0
~
ill
Fig. 1 10 Control
lever: Changing spee d
- Press the lever briefly upwards 0
~
fig. 110 . USA
models : the speed increases by about 2.5 mph . Canada
models : speed will increase by one mark on the speedom-
eter scale .
- Press the lever upwards
0 and hold it . As long as you hold
the control switch down, the light diode display in the
speedometer LED display in the speedometer moves
forward and the speed is increased .
Re ducing speed
- Press the lever downwards briefly Q. USA models : the
speed decreases by 2 .5 mph . Canada models: speed will
decrease by one mark on the speedometer scale . _,.
Vehicle care Do-it-yourselt service iTechnical data
To Next Page
Loading...
